<address id="vbhzt"></address>
    <noframes id="vbhzt"><form id="vbhzt"><nobr id="vbhzt"></nobr></form>

        <address id="vbhzt"></address><form id="vbhzt"><nobr id="vbhzt"><progress id="vbhzt"></progress></nobr></form>

            <address id="vbhzt"></address>

            歡迎訪問合肥通用機械研究院!
            聯系電話:韓工(15395150883)
            (0551-65335570)
            水射流清洗產品
            水射流清洗產品
            機械密封產品
            風機產品
            泵產品
            儲油罐機械清洗成套設備 當前位置:首頁 > 水射流清洗產品 > 儲油罐機械清洗成套設備
             
             
            TankCleaning
            來源: 發布時間:2019/11/15 10:14:09 發布人:

            Crude oil tank cleaning Equipment


            1、Crude oil tank cleaning equipment working principal introduction

            1.1 Working Principal

            At first, using the temporary pipes connect the 150,000m3 crude oil tank or smaller and the equipments to be a closed loop cleaning system . after that, use the same oil as the tank storage to broke the oil sludge. when the sludge is broken, to become liquid and small, it will be pumped out, and be separated、recycled, when most sludge and oil is pumped out, than, using hot water to clean the tank, at last, the tank will be cleaned up. This closed process is called crude oil tank cleaning technology.


            1.2 technological process

            Bottom oil transfer→ inject Nitrogen→ oil cleaning→hot water cleaning→open manhole/ventilate→clear up


            2、Product oil storage tank cleaning system working principal introduction

            2.1 working principal

            At first, using the temporary pipes connect the 50,000m3 refined oil tank or smaller and the equipments to be a closed loop cleaning system . after that,  using hot water to clean the tank, the oil /water will be pumped out, and be separated、recycled , at last, the tank will be cleaned up. This closed process is called refined oil tank cleaning technology.



            2.2 technological Process

            Equipment installation→inject Nitrogen→hot water cleaning→open manhole/ventilate→clear up


            3、Equipment introduction

            The GM tank cleaning system is used for cleaning the 1,000 m3-150,000 m3 crude oil tank and product oil tank.

            3.1 Equipment composition

            Cleaning /recycling module Vertical Spray Guns Side wall spray guns Nitrogen generator skimming module Tube & Pipe Assy



            Cleaning /recycling module

            The cleaning /recycling module include recovery pump unit、ejecting pump unit、vacuum pump unit and O2 monitor. All of these units integrate in a open type container.



            Tube & Pipe Assy: diaphragm pump、switch box、cable、air compressor、filter、pipes、valves, and so on.


            3.2 Technical specifications

            No

            name

            type

            GM-L

            GM-M

            GM-S

            Rang of application

            150,000 m3and smaller crude oil tank

            50,000 m3and smaller crude/product oil tank

            30,000 m3and smaller crude/product oil tank

            1

            Cleaning /recycling module

            flow

            180m3/h

            120m3/h

            80m3/h

            vacuum draw

            230m3/h

            165m3/h

            detection object

            O2、 flammable gas

            detecting point

            6 points

            4-6 points

            power

            155 kW

            115kW

            95kW

            dimension

            7m×2.3m×2.7m

            6.5m×2.3m×2.5m

            6.5m×2.3m×2.5m

            2

            Vertical Spray Gun

            flow

            40m3/h~80m3/hADJ

            pressure

            0.5MPa~0.7MPa

            3

            Side wall spray gun

            flow

            /

            40m3/h~90m3/hADJ

            pressure

            /

            0.5MPa~0.7MPa

            4

            Nitrogen generator

            generation rate

            300m3/h

            200m3/h

            purity

            99%VOL

            5

            Skimming

            module

            dimension

            7m×2.3m×2.6m

            6m×2.3m×2.6m

            volume

            20m3

            15m3

            6

            Diaphragm pump

            /

            flow:24m3/h, pressure:0.6MPa

            7

            Switch box

            /

            400A,EXDIIBT4,IP55, leakage protection

            8

            Cable

            /

            Three phase/anti-flaming/wear resistant

            9

            Air compressor

            /

            EXDIIBT4,IP55

            10

            Filter

            /

            Double type DN 600,bear pressure 1.6MPa,quick-open type

            11

            Pipe

            /

            bear pressure 1.6MPa, static conductivity

            3.3 Oil and Solid separator

            The oil and solid separator consists of pre-treatment system、feed pump、centrifugal machine、chemical dosing system 、screw conveyer、 fuel delivery pump and so on, fit for separating the solid、water and oil .



            oil and solid separation effect


            4、technical advantage

            (1) Safety: Explosion proof design, the nitrogen generator is the safety guarantee.

            (2) Efficiency: all mechanical work, 24 hours continue working, no person entry the tank in cleaning process.

            (3) Environmental friendliness: fully closed pipelining operations, no oil leakage, no pollution.

            (4) Efficiency: oil/water separator make the water can be recycled.

            (5) Professional: more than 200 spray guns be used in cleaning tank, our oil tank cleaning system have cleaned more than 200 tanks for petroleum/Sinopec/National oil storage base in China and southeast Asia customer .

            (6) Technological Achievements: the oil tank cleaning system has our own many invention patents, won “China machinery industry science and technology first prize” , and set a machinery industry standard JB/T 13138-2017.

            5、Engineering Projects

            The GM large oil storage tank cleaning equipments have been used to clean many big tanks in Xinjiang province/Gansu province/Zhejiang province/Sichuan province/Xian province/Beijing/Tianjin and in Southeast Asia, the good cleaning effect get the customers high praise.





            公司地址:合肥市蜀山區長江西路888號 郵編:230031
            電話:0551-65335504 65335570 65335573 郵箱:13966779237@163.com
            版權所有:合肥通用環境控制技術有限責任公司 Copyright@ 2006-2019 All Rights Reserved 皖ICP備05012209號-3 站長統計 技術支持:安徽三戶網絡
            亚洲av综合av一区加勒比 <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <蜘蛛词>| <文本链> <文本链> <文本链> <文本链> <文本链> <文本链>